![]() ![]() ![]() Remaining to be done are mounting holes on the pcb silkscreen (and on BB where they are present but probably not in the correct position) and the board outline which need measurements from a real board. The labels have been corrected so that hovering over a pin will give you the label that appears on the PCB for that pin, the pin number (1 to 30, which also now appears on the pcb silkscreen) and your description of alternate uses. Pin numbers now start at 0 with pin 1 (connector0 internally) the bottom right pin. Pcb has a bunch of unneeded elements removed and the pads with holes set to 0.038in (suitable for. All the svgs have been rescaled to standard scale, Schematic has been made smaller and to match the bb and pcb views. Breadboard has been fully implemented so it now works correctly (that is probably the most visible change). Much of the change isn’t visible directly. OK here is an improved (but likely not a direct replacement) version of your part. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |